General "Woof" Tip: Very important to pay attention on what kindÂ
of rivets is used to make your leather product. Some companies trying to cut down prices and use low quality rivets which will rust within weeks and can harm you and your dog because edges are sharp and not polished.
1. Use it for years as it is made of heavy duty European leather
2. Use it for years as it is made with luxury brass buckle and massive strong ring for mounting the leash hassle free
3. Gain better control over your dog with super grip padded handle
4. Take care of your dogs throat and trachea - terrific 1 3/4 inch (45 mm) width absorbs most of the pressure while your dog pulls.
5.Use adjustability at your favor to save a lot of money as your dog grows or goes on diet - no need to buy new collar
6. Protect your dogs fur using "keep it firm" buckle protection leather tongue.
7. Stun your friends and neighbors with super look of this Gladiator look collar.
General "Woof" Tip: Using right material for padding is crucial for your dogs comfort – good padding  should be of natural origin to avoid rubbing and irritation of your dogs skin and fur. Please be very careful when you select padded dog product, check how padding attached to the chest plate or other padded areas. Glued padding is not the best way to make good padded harness, muzzle or collar, stitching might be much better idea, hand stitched products will cost more, however this is the best way to make product which serves for lifetime.
2 ply Leather Working Dog Collar for Alapaha Blood Bulldog Â
Please, make sure you read how to measure section to get the best fit collar and to avoid exchanges and other inconveniences.
How to measure your Dog for good fit Collar:
Please be advised that:
- Always measure your dog neck circumference with the flexible measuring tape.
- Specify neck size of your dog and we will make this size fit on central hole.
- There will be total of 5 holes and distance between each 2 holes is 1 inch (25 mm).
- For example: your dogs neck size is 20 inches (50 cm). Collar will fit on central hole at 20 inches (50 cm).
- There will be 2 smaller size holes - 18 inch (45 cm) and 19 inch (47.5 cm).
- There will be 2 bigger size holes - 21 inch (52.5 cm) and 22 inch (55 cm).
- There will also be tip of the collar after last hole about 4 inch long (10 cm).
- Those are handcrafted collars and some sizes will differ a little (not in significant way).
- When you measure already received collar on the dog you have to measure the inner part of the collar with the flexible measuring tape.
- 2 ply leather collars if measured laying flat on the table are 2 inch bigger than if measured on the dog.
